That's HEAVY squatting. I'll look forward for your progress next week after the trip
That's HEAVY squatting. I'll look forward for your progress next week after the trip
Sorrow, at what point in the movement did you (or do you typically) find as the weak point? Off the floor? Floor to knees? Knees to lockout? Just curious.
All advice given is for entertainment value only. And it's free. Take it for what it's worth.
11/5/2013
Bench day
Body weight: 248
warmed up raw
bar x 5
135 x 5
225 x 5
275 x 3
315 x 3
365 x 2
Added Metal JAck bench shirt
455 x 2 to a 2.5 board
535 x 1 to a 2 board
590 x 1 to a 1 board (another grinder)
At this point I think 590 / 600 is probably the absolute limit for my equipped bench. Mostly wanted to work on getting some heavy weight in my hands and work down to low boards. Not sure where to adjust the shirt to get it to touch like I'm used too. I don't mind having to grind out the 590 as I did get it in the end. No accessory work tonight. Probably get that in friday night.
Sounds similar to me. If I can lift it the first 6", the lift is as good as done. And there are times I am, like you, a bit too much over the bar and I can't even get it off the ground at all!
One and halfs? Never heard of that. Do one full rep, then 1/2 rep and repeat?
I've heard the term deficit pulls, but have no idea what that is, either. Educate me in the PL lingo, brother!
All advice given is for entertainment value only. And it's free. Take it for what it's worth.
POWERLIFTERS PUT IT DEEPER IN THE WHOLE!!! WHAT???!!!
Yeah one and halfs I'll see if I can find a video of us doing. There's basicly two ways to do it
1) You setup and start a deadlift pulling to the top of your knees, then stop and reverse back to the floor, but as soon as you feel it touch bottom, you explosively launch all the way to lockout. Then return all the way to the floor. Thats one rep.
2) You setup like normal and perform one full pull all the way to lockout, then control the weight down pushing your hips back like normal, to the top of your knees. Then explosively pull back up too lockout. Then lower all the way to the floor. Thats one rep.
I usualy do option 1 to work my start. It provides a little stretch reflex to the hamstrings kind of like on the bench or squat. There may be a video of my doing them somewhere, I'll post it if I find it.
Deficit pulls,
I have the same issue with my knees going to far forward if Its too high. I figured out I could use thin sheets of plywood to change the height slightly. Small jumps at a time. But, it is very productive! By extending the total duration of the lift and being slightly out of position deeper then normal you really work the whole movement.
If I could just find 45s in a 30 inch diameter I wouldn't have a problem at the bottom. Lol
All advice given is for entertainment value only. And it's free. Take it for what it's worth.